Drake Landing Solar Community
Home / Solar panels / RV solar system basics for campers and trailers

RV solar system basics for campers and trailers

A solar system for an RV needs four parts that work together: solar panels, a charge controller, a battery bank and, if you run household appliances, an inverter. Size it from the watt-hours you actually use each day, not from the number of panels that fit on the roof.

Last updated

How do RV solar panels work with a 12 volt system?

Most RVs run their lights, fans, water pump and fridge controls from a 12 volt battery system, often called the house battery. The panels turn sunlight into DC power, the charge controller regulates that power, and the battery stores it for the evening. Everything on that side runs directly from the battery. Appliances that need household AC power, such as a microwave or coffee maker, need an inverter between the battery and the plug.

Rooftop panels carry a rating in strong, direct sun, so a 200 watt array delivers less than that most of the day. Clouds, dust, heat, shade from a vent or air conditioner and the angle of a flat-mounted panel all reduce output. The same system that works well on a summer day in southern Alberta will produce far less in a December campground under the trees.

How much solar does an RV need?

Start with a simple energy audit. List each device, how much power it draws and how long you run it each day, then add up the total. The unit is the watt-hour, explained in what is a kilowatt-hour.

Here is a worked example with assumptions, not a rule:

  • LED lights, about 20 W for 4 h, so roughly 80 Wh
  • a roof fan, about 30 W for 6 h, so roughly 180 Wh
  • a pump plus phone and laptop charging, together roughly 250 Wh
  • a 12 V compressor fridge, perhaps 400 to 600 Wh depending on the weather and how often it is opened

That totals roughly 900 to 1,100 Wh. Divide by the peak sun you can expect, and add a margin for losses. With about 4 peak sun hours, a rough figure is 1,000 divided by 4, so 250 W, and with losses a system closer to 300 to 400 W is reasonable. Peak sun hours across Canada vary by region and season, which is why a trip in June and a trip in November need different numbers.

A battery monitor is a good first purchase because it shows what you really use. Real consumption often differs from the estimate.

Do you need a charge controller?

Yes. A solar charge controller sits between the panels and the battery, stops overcharging, and charges in stages so the battery lasts. Connecting a panel straight to a battery risks damage. The controller must match the battery type and be rated for the voltage and current of the array.

The two common types are PWM and MPPT. PWM controllers are simpler and cheaper. MPPT controllers convert extra panel voltage into extra charging current, which helps most with larger arrays, cold weather and panels wired in series. The full comparison is in the charge controller guide. For a small RV system, check the controller's maximum input voltage and charge current against the array on its datasheet before buying, because a controller that is too small is a common mistake.

Which battery works best for RV solar?

The battery bank sets how long you can stay without sun, and its capacity is usually listed in amp-hours. At 12 V, 100 Ah is about 1,200 Wh on paper, but you cannot use all of it. Flooded and AGM units should not be drained below roughly half to protect its life, while lithium iron phosphate can be used much deeper. Lithium costs more up front, weighs less and handles daily cycling well; the older type is cheaper and heavier. Lithium versus lead-acid solar batteries compares them in detail.

Cold matters in Canada. Most lithium units should not be charged below freezing unless they have built-in heating, and older chemistries lose capacity in the cold. Solar battery performance in cold weather covers what to look for in a battery for winter trips. Where the battery sits, in a heated compartment or an exposed box, also changes the answer.

What does boondocking need from a solar system?

Boondocking means camping off-grid without hookups, so your own panels, batteries and perhaps a backup supply every bit of power. Many RVers use solar mainly to keep the bank topped up and cut how often the engine-driven set has to run. A fridge, lights and electronics are realistic. An air conditioner or an electric heater is not; they draw thousands of watts and would need a very large battery bank and inverter.

An inverter converts battery power to AC. Its rating should cover the largest appliance you plan to use, and a bigger one also wastes more power when idle; see solar inverter types explained. Some campers add a portable solar suitcase that can be set in the sun while the rig sits in shade, which is covered in portable solar panels in Canada. A small portable set or a solar powered generator can cover the gaps.

How are RV solar panels installed, and who should do it?

Rooftop panels are mounted with brackets and sealed at each fixing, and the cable has to enter the rig through a sealed gland. Wire size and fuses depend on the cable length, and a fuse should sit close to the battery. Wiring mistakes can cause fires, so anyone unsure should hire a qualified RV technician or electrician. When you want to install a kit, note that parts are matched, though each one should still suit your battery and your DC wiring. Many owners keep the system on 12V and plan installation for several years of use.

For the weight, check the roof rating and the payload limit of the vehicle, since panels, batteries and an inverter all add mass. Leave space around the air conditioner and vents, and plan the cable route before drilling. A cabin or camp that stays put follows similar rules; see solar power for a cabin and the off-grid solar guide for fixed sites.

Quick answers

How many solar panels do I need for an RV?

It depends on daily use. Add up the energy of everything you run, divide by the peak sun for the season and add a margin for losses. Many small RV setups land in the range of a few hundred watts, but the calculation decides.

Can solar panels run an RV air conditioner?

Not normally. A rooftop air conditioner draws a large amount of power for hours, which would need a very large array, a big battery bank and a large inverter. Most owners use shore power or a generator for air conditioning.

Do I need a battery with RV solar panels?

Yes, for use at night and on cloudy days. The panels only produce while the sun is up, so RV batteries store the solar energy and supply the loads.

Is 12 volt or 24 volt better for an RV?

12 volt DC is the usual choice for small and medium RVs because most appliances and parts are made for it. Larger systems sometimes use higher voltage to reduce current and cable size.

Where to verify

Programmes, rules and prices change. Before acting on anything you read here, check it at the source:

  • Natural Resources Canada: federal energy-efficiency and clean-energy pages: programme status, EnerGuide labels, technical background.
  • Your provincial electrical or building safety authority: permit, inspection and code requirements, including the edition of the Canadian Electrical Code in force.
  • Product certification marks: look for a recognised Canadian certification mark (for example CSA) on electrical and gas equipment.
  • Your electricity or gas utility: rates, connection requirements and any utility incentive.
  • A licensed professional in your province: sizing, safety and installation for your particular building; these guides are general background only.

dlsc.ca is an independent information site. It sells and installs nothing and gives no personal advice.

Part of the topic: Solar panels. See all guides on this topic.

More guides on this topic