Solar panels and a heat pump: do they work together?
Yes. A heat pump runs on electricity, so rooftop solar can generate part or all of the energy it draws over a year. The pairing works as an annual balance on the grid, not as direct daytime power, because heating demand peaks in winter and solar output peaks in summer.
Last updated
How do solar panels and a heat pump work together?
A heat pump moves heat from outdoor air or the ground into the home. For each unit of electricity it uses, it delivers several units of heat, and the ratio falls as the weather gets colder. Rooftop solar generates electricity from sunlight, with no connection to the heating system itself. The two are linked only through the electric panel and the meter.
In practice, the panels feed the home's loads during sunny hours, and any surplus flows to the grid. When the sun is down or the sky is dark, the heat pump draws from the grid. Over twelve months, a properly sized solar system can generate about as much as the heat pump and the rest of the house need, a goal some homeowners call energy independence. A battery can shift some solar energy into the evening, but battery storage adds cost and is a separate decision, covered in solar battery sizing in Canada.
How much electricity does a heat pump add to a home?
The added demand depends on the heating load, the efficiency of the heat pump and the climate. Broad published ranges for a cold-climate air source heat pump heating a typical Canadian house are in the low thousands of kWh a year, and a large or poorly insulated home can use well above that. A house in Alberta uses more heating energy than one on the BC coast.
Worked example, with stated assumptions: a house that burned the equivalent of 20,000 kilowatt hours of gas in a furnace at about 95 per cent efficiency needs roughly 19,000 of delivered heat. A heat pump with a seasonal average coefficient of performance near 2.5 would produce that heat from about 7,600 kWh. Your own figures will differ, which is why a heat loss calculation matters. Plans that skip it tend to miss. The guide on heat pump electricity use in Canada walks through the arithmetic, and heat pump sizing for cold climates explains why oversizing the unit wastes money.
How do you size solar panels for a heat pump?
Sizing starts with the whole home's annual consumption, not with the heat pump alone. The steps include:
- Collect twelve months of use from utility bills, in kWh.
- Add the expected increase for the heat pump. If you are replacing a gas furnace, a heat loss estimate or a quote from a licensed installer supplies it.
- Divide by the annual output of one kilowatt of panels in your location, typically somewhere around 1,000 to 1,400 kWh per year in much of Canada.
- Check that the roof has room, since the result may be larger than a house without electric heating needs.
Continuing the example: a home using 8,000 now and adding 7,600 for heating would need 15,600 kilowatt hours. At 1,200 kWh per kilowatt of capacity, that suggests a solar array of about 13 kW, well beyond what many roofs can hold. Many owners aim at part of the load rather than all of it. The guides on how many solar panels it takes to power a house and roof space for solar panels cover the next steps.
Does net metering help a solar and heat pump home?
Net metering is the rule that credits surplus sent to the grid, so a summer surplus offsets winter demand. For a heat pump home it is the main way the annual balance works. Terms differ by province and utility. Some programmes credit surplus at the retail rate and some at a lower rate, some roll credits over for a limited time and some cap system size. Check the current terms with your utility and your provincial energy ministry before you design the array.
The explainer on net metering in Canada describes the common models, and Alberta rules cover one province in detail. If the credit for exports is low, a smaller system sized to daytime use can change the economics. That is a question for the quote, not a rule.
What does it cost, and what about rebates?
Costs vary by region, year and installer, so quotes decide. As broad context, a heat pump installation and a solar installation are each a significant spend, and the combined investment depends on array size, heat pump type, ductwork and electrical work. The main drivers are listed in solar panel cost drivers in Canada and heat pump cost in Canada.
Rebates and incentives for heat pumps and for solar exist in some provinces and from some utilities, and they change. Ask the provincial energy ministry, the utility and the Government of Canada energy-efficiency pages what is current, and confirm eligibility rules and whether two programmes can be combined. Nothing here promises savings. Savings depend on your current heating fuel, your electricity rate and the performance of both systems.
What should you check before installing both?
- Electrical service. Both systems require capacity, and a breaker panel upgrade may be needed. An installer or electrician assesses that.
- Order of work. Many households install the heat pump first, then size the solar array to the new electricity use rather than guessing.
- Backup heat. A cold-climate air source heat pump may need a backup in extreme cold, discussed in heat pump backup heat.
- Winter output. Panels produce less in December, partly from snow cover, as explained in solar panels in winter. Operating costs of the heat pump are then met mostly from the grid.
- Cooling. In summer the heat pump can cool the home while the panels generate their peak, a useful overlap.
For the wider picture of replacing fossil heat with electricity, see electrification of home heating in Canada.
How does this compare with solar heat at DLSC?
Drake Landing in Okotoks, Alberta took a different route. Its solar collectors gathered heat directly and stored it in the ground for winter, and the page on how DLSC works explains the design. Solar plus heat pump systems convert sunlight to electricity first and then to heat, and they rely on the grid to balance the seasons. Seasonal storage moves heat itself from summer to winter. Both aim to cover winter heating with summer sun, using different equipment.
Quick answers
Can solar panels run a heat pump?
A solar system can generate the energy a heat pump uses over a year, but the match is seasonal rather than hourly. In winter the home draws from the grid, and summer surplus offsets it where the utility allows.
How many solar panels do I need for a heat pump?
It depends on annual electricity use, the heating load and the output of your location. Many homes need several additional kilowatts of capacity once a heat pump replaces gas heating. Some homeowners plan the project in two stages.
Should I install solar or the heat pump first?
Many households install the heat pump first, so the solar array can be sized to the new electricity use. An installer can advise on the order for a specific home.
Do solar panels and a heat pump save money?
It depends on the old heating fuel, electricity rates, net metering terms and installation cost. A quote and a heat loss estimate allow a fair comparison.
Where to verify
Programmes, rules and prices change. Before acting on anything you read here, check it at the source:
- Natural Resources Canada: federal energy-efficiency and clean-energy pages: programme status, EnerGuide labels, technical background.
- Your provincial or territorial energy ministry: current rebates, rules and programme intake dates.
- Your electricity or gas utility: rates, connection requirements and any utility incentive.
- Environment and Climate Change Canada: climate normals and weather data for your area.
- A licensed professional in your province: sizing, safety and installation for your particular building; these guides are general background only.
dlsc.ca is an independent information site. It sells and installs nothing and gives no personal advice.
Part of the topic: Heat pumps. See all guides on this topic.