Drake Landing Solar Community
Home / Guides / Seasonal storage and district heating

Seasonal storage and district heating

Seasonal storage moves summer heat to winter. The idea sounds simple and the engineering is not, which is why a working example like Drake Landing drew so much attention.

Last updated

About this topic

Seasonal storage moves summer heat to winter. The idea sounds simple and the engineering is not, which is why a working example like Drake Landing drew so much attention.

These guides compare storage types, explain thermal mass, and show how a district loop shares heat between homes. Start with how Drake Landing worked, then use the pages below for the wider technology.

All 20 guides on this topic

  • Community energy: shared heat, power and planning: A community energy system is a source of heat, electricity or both that serves a group of buildings or a whole neighbourhood, instead of each building having its own equipment. In Canada the term covers district energy loops, shared solar, community-owned renewables and local microgrids, usually backed by a municipal or cooperative owner.
  • Could Drake Landing Be Rebuilt Now?: Technically yes, but the economics are uncertain and depend on scale, site and the cost of alternatives such as heat pumps. Drake Landing proved the engineering and also showed how hard long-term upkeep can be.
  • Heat Pits: Storage in a Lined Hole: Pit thermal energy storage keeps heat in a large, lined excavation filled with water or a gravel-and-water mix and sealed with an insulated lid. It is a seasonal store that trades drilling for earthworks.
  • How thermal mass works in a house: Thermal mass is the ability of heavy materials such as concrete, brick, stone and water to absorb heat and release it slowly. In a home it evens out temperature swings between day and night, but it is not insulation, and it pays off only when it sits in the right place.
  • Low-temperature district heating networks: Low-temperature district heating delivers heat through a loop of relatively cool water, often around 50 to 60 degrees C or less, instead of very hot water or steam. The lower temperature loses less heat in the pipes and lets heat pumps, solar collectors and waste heat feed the network, but the buildings must be able to heat comfortably with cooler water.
  • PCM in the home: latent heat storage explained: A phase change material, or PCM, stores heat by melting and releases it by freezing at a set temperature. In a home it can soften temperature swings and store solar heat in a smaller volume than water or masonry, but it is still a specialist product with real trade-offs in cost, durability and evidence.
  • Seasonal heat storage economics: why few projects follow: Seasonal thermal energy storage (STES) is technically proven, but it is hard to repeat because a store that fills once a year earns back its capital slowly, needs a large and dense heat demand, loses some heat while waiting and competes with cheap fuel. The engineering usually works. The business case is the obstacle.
  • Shared Heat Networks, Explained: District heating is a network of insulated pipes that carries hot water from a central plant to many buildings, replacing a boiler or furnace in each one. It works best where buildings are close together and heat demand is steady.
  • Shared Plant or a Furnace in Each Home: District energy centralizes heat production and piping, while individual heating puts a furnace, boiler or heat pump in every building. Neither wins everywhere; density, fuel source and who owns the system decide.
  • Solar district heating: shared collectors, shared loop: Solar district heating gathers heat from a field of solar collectors and sends it through buried pipes to many buildings, instead of putting collectors on each roof. In Canada the hard part is winter, so most designs pair the collectors with storage and a backup heat source.
  • Storing Summer Heat for the Winter: Seasonal thermal energy storage keeps heat collected in summer for use months later, usually in a large mass of earth, water or gravel. It matters in Canada because the sun is strongest when heating demand is lowest.
  • The district loop: how heat travels between buildings: A district loop is a closed circuit of insulated pipes that carries heated water from a central plant to several buildings and returns the cooler water for reheating. It is the part of a district heating system that links the heat source to the homes, so its temperature and layout decide how efficient the whole system can be.
  • The Slow Start of a Ground Heat Bank: Seasonal storage takes years to reach full output because the ground around it starts cold and swallows heat before it can return any. Drake Landing's borehole field needed about three years to build up.
  • Thermal Energy Storage in Plain Terms: Thermal energy storage means holding heat or cold in a material so it can be used later, hours or even months afterward. The simplest and most common form is hot water in an insulated tank.
  • Using Groundwater to Store Heat and Cold: Aquifer thermal energy storage (ATES) uses natural underground water layers as a store: warm water is pumped in during summer and drawn out in winter, usually with a cold well alongside. It works only where the geology suits.
  • Water thermal storage tanks, from homes to districts: A thermal storage tank is an insulated vessel of water that stores heat (or cold) produced earlier and releases it when needed. Water holds a lot of heat per litre and costs little, which is why tanks are the most common form of thermal storage in homes, buildings and district heating.
  • Ways a House Can Store Energy: Homes can store energy as electricity in batteries, as heat in water tanks or heavy materials, and at larger scale as heat in the ground. Each type suits a different job, and heat is usually far cheaper to store than electricity.
  • What a solar fraction tells you about a system: The solar fraction is the share of a building's energy demand that a solar system covers over a stated period, usually a year. A 60 percent solar fraction means the sun supplied 60 percent of the heat or power and something else supplied the remaining 40 percent.
  • What Counts as a Solar Community?: A solar community is usually a group of buildings that share a solar energy system or are planned around one, but the term has no single official definition. It can mean shared solar heat, shared solar electricity, or simply a neighbourhood with a lot of rooftop panels.
  • What Drake Landing Taught About Net-Zero Heat: Drake Landing showed that a Canadian neighbourhood can meet nearly all of its space heating with summer sun, using seasonal storage and efficient homes. It also showed that keeping such a system running for decades is the harder test.

Where to verify

Programmes, rules and prices change. Before acting on anything you read here, check it at the source:

  • Natural Resources Canada: federal energy-efficiency and clean-energy pages: programme status, EnerGuide labels, technical background.
  • Published project reports and papers: the Drake Landing monitoring results and the publications page on this site.
  • Environment and Climate Change Canada: climate normals and weather data for your area.

dlsc.ca is an independent information site. It sells and installs nothing and gives no personal advice.