Drake Landing Solar Community
Home / Solar panels / How Heat and Cold Change Solar Panel Output

How Heat and Cold Change Solar Panel Output

The temperature coefficient shows how much power a solar panel loses for each degree Celsius above 25 °C. Typical silicon panels lose roughly 0.3 to 0.5 percent per degree, so hot panels lose power and chilled panels run more efficiently, though short winter days still limit winter output.

Last updated

What is the temperature coefficient of a solar panel?

The temperature coefficient of a photovoltaic (PV) module is a number on the panel datasheet, usually listed for maximum power and written as a percentage per degree Celsius, such as -0.35 %/°C. The minus sign means output falls as temperature rises. Panels are labelled under standard test conditions: a cell temperature of 25 °C and 1,000 watts per square metre of sunlight. Real roofs rarely match those conditions, so the coefficient is the tool for adjusting the nameplate power to real life. A temperature coefficient calculator is just this arithmetic: degrees away from 25 times the percentage.

Datasheets also list coefficients for voltage and current. Power and voltage fall as the silicon warms, while current rises very slightly. A lower (less negative) coefficient is better for hot sites, and it varies by cell type and design, so compare the datasheets of the modules you are considering. A guide on solar panel efficiency explains the other ratings that appear next to it.

How does heat reduce solar panel output?

Solar cells are semiconductors. When they warm up, more electrons are freed by heat rather than by light, the voltage drops, and the power drops with it. Performance at the roof is therefore below the label on a hot day. The result is a power loss that grows with every degree above 25 °C, and the electricity that panels generate falls with it.

An example with stated assumptions. A 400 W panel has a coefficient of -0.35 %/°C. On a warm, bright day with an air temperature of 30 °C, the panel on a roof may run roughly 20 to 30 degrees hotter than the air, say 55 °C. That is 30 degrees above 25 °C, a loss of 10.5 percent, so the panel delivers about 358 W in full sun. The loss is real, but it is a percentage of power that is already high because the sun is strong, and it will matter most in hot climates. Efficiency losses of this size are common in July and are easy to forget in winter.

Airflow helps. Panels mounted with a gap beneath them shed heat better than panels sitting tight on a surface. See solar panel roof requirements for mounting basics.

Do solar panels work better in cold weather?

Per hour of sunlight, yes. Chilled cells are more efficient, and the same coefficient works in reverse below 25 °C. Using the same panel, a cell temperature of 0 °C is 25 degrees below the test condition, which suggests an increase of about 8.75 percent in power output at the same sunlight. That is the sensible ceiling: claims of 15 or 20 percent should be treated with caution, since cell temperature in sun is seldom as low as the air.

Low temperatures also raise the voltage of the panels. A string of panels on a very frosty, clear morning can produce a higher voltage than on the datasheet's test point, so system designers check the coldest expected temperature against the maximum input voltage of the inverter. This is a design check for the installer and the electrical inspector, not something to guess. The guide to solar inverter types covers the equipment side.

Clear, frosty days with sunlight reflected off snow can therefore give some of the best output per hour of the year. That is why Canadian systems often perform better in sunny winter weather than their rating would suggest. Batteries are different, since they dislike low temperatures, as covered in solar battery in cold weather.

Why is winter output still lower?

Efficiency is only one part of production. Winter production depends on the amount of sunlight reaching the panel, and in winter that amount is small. Days are short, the sun sits low, clouds are common and snow may cover the modules. The gain from cold temperatures is measured in single-digit percentages, while the drop in sunlight from summer to midwinter is far larger. In most of Canada, December produces only a small fraction of what July does.

So the practical answer is that cold weather efficiency is a bonus and not a cure, and total energy still follows the sun. The solar panels in winter guide shows the seasonal shape, and peak sun hours explain the maths. Snow cover is a separate loss: see solar panels snow removal before climbing a ladder.

What does this mean when comparing panels?

Check four things on the datasheet and in the estimate, because small differences will add up over decades:

  • The temperature coefficient of power. Less negative is better where summers are hot, and it matters little in a cold, windy place.
  • The rated operating temperature range, so the panel is built for both a hard freeze and a hot summer.
  • The panel type. Monocrystalline solar panels and newer cell designs often have lower coefficients than older types, though datasheets vary.
  • Whether the production estimate includes temperature effects, as explained in how to read a solar production estimate.

Shade causes bigger losses than temperature in many homes. A guide to shading and optimizers compares the two.

Does temperature matter for solar heating collectors?

Yes, in a different way. A collector that makes heat, rather than electricity, loses heat to the outdoor air through its glass and frame, and the difference between its temperature and the outdoor temperature drives that loss. The 800 flat-plate collectors at Drake Landing, described on the solar collection page, operated in Alberta's winter sun with insulated backing and glazing to limit the heat loss. See evacuated tube vs flat plate collectors for how the designs differ.

Quick answers

What is a good temperature coefficient for a solar panel?

A smaller negative number is better. Many silicon panels fall around -0.3 to -0.4 percent per degree Celsius, and some newer designs are lower, which means smaller power loss in heat.

Do solar panels produce more in cold weather?

They are more efficient per hour of sun at low temperatures, but total winter production is still lower because of short days, low sun and snow.

At what temperature do solar panels lose efficiency?

Rated power is defined at a cell temperature of 25 °C, and output falls gradually above that, by the percentage on the datasheet for each degree.

Can cold damage solar panels?

Panels are tested for wide temperature ranges and are built for Canadian winters, so frost on its own is not a concern. Check the operating range on the datasheet.

Where to verify

Programmes, rules and prices change. Before acting on anything you read here, check it at the source:

  • Natural Resources Canada: federal energy-efficiency and clean-energy pages: programme status, EnerGuide labels, technical background.
  • Your provincial electrical or building safety authority: permit, inspection and code requirements, including the edition of the Canadian Electrical Code in force.
  • Product certification marks: look for a recognised Canadian certification mark (for example CSA) on electrical and gas equipment.
  • Your electricity or gas utility: rates, connection requirements and any utility incentive.
  • A licensed professional in your province: sizing, safety and installation for your particular building; these guides are general background only.

dlsc.ca is an independent information site. It sells and installs nothing and gives no personal advice.

Part of the topic: Solar panels. See all guides on this topic.

More guides on this topic